General – IRWIN

How do I change the batteries?
How do I get this tool to stick to the wall?
As a mason who works on large job sites, I have dropped a level and now the level no longer work properly.
I just used the large hole saw to drill through my door and it worked great. Now I have to use the small hole saw and the mandrel-pilot bit will not fit into it. What should I do?
I just took this tool out of the package and put the batteries in. I have very faint lines showing. Does this tool need to be returned?
I have an older model DeWalt miter saw (DW704). Will this product work on my saw?
I have a radial arm saw. Will this product work on my saw?
I drilled the large hole in my door and have also drilled the small hole, but the small hole does not go all the way back to the large hole. What can I do?
I can’t get both bubbles to line up at the same time, can you help me?
I am crosscutting oak veneer plywood on a table saw, and the veneer is chipping on the backside. What type of blade would you recommend to cleanly cut across plywood?
The stud finder part of this tool is working but the laser part is not. What should I do?
My tool was working fine a month ago. Now, I have a very faint line where I’m trying to work and a bold line and big dot on the other wall. What can I do to fix this tool?
My rolling tape keeps giving me the same measurement, even though I’ve measured 2 different distances. Is this tool defective?
My rolling tape is not working. Can you help me?
My rolling tape is about 2-1/2” off. Is this tool defective?
Mitersaw Laser Guide useful information
I recently purchased a cargo trailer. There are 2 screws that hold the license plate bracket on. I cannot identify the screw drive type. At first glance I thought it was a Torx head, but upon closer examination and trial I noticed that the star has 8 poin
Every time I snap a chalk line, a huge cloud of chalk forms in the air. Why?
The display on my rolling tape keeps flashing and will not give me a reading. Is this tool defective?
What will remove the permanent staining chalk?
What is the proper way to use the reversible offfset dovetail saw? I know it is reversible and it has an offset. What side needs to be offset in relation to the side of the cut?
Can I drill out the arbor to make this fit my saw? Why or why not?
IRWIN Taps & Dies information:
I was trying to tap a hole in aluminum with a 1/4" tap. Half of the tap broke off in the workpiece. How do I get it out?
I plan on using my hole saw to cut into iron. What RPM should I use for best results?
What is the difference between a nutsetter that has a standard hex design vs. one that has a lobular design?
Sometimes working alone, working with a level seems so clumsy. How can I free up a hand?
Can Irwin snips be resharpened?
Can IRWIN chisels be re-sharpened? If so, what's the best angle to re-sharpen at?
I just purchased Irwin straight chalk line and I don't know how to use. It doesn't have any instruction on how to use it. Do I need to pour the chalk into the tool? or do I need to wet the string and put chalk on it?