A very common application for the reversible offset dovetail saw is to cut off the bottom of door trim when putting down flooring such as tile, which is thick. Many people will remove base molding but not the door trim when putting down flooring. You should cut off the bottom of the door trim to slide the tile underneath the trim. The offset handle enables you to put the saw parallel to the floor to cut the trim. When cutting off the trim for tile, users will turn the tile upside down for the proper thickness and so they don't scratch the finished surface then cut the trim. It is reversible in case the door is close to a corner and the trim couldn't be cut. It also makes it easier for left and right hand persons.
Articles in this section
- How do I change the batteries?
- How do I get this tool to stick to the wall?
- As a mason who works on large job sites, I have dropped a level and now the level no longer work properly.
- I just used the large hole saw to drill through my door and it worked great. Now I have to use the small hole saw and the mandrel-pilot bit will not fit into it. What should I do?
- I just took this tool out of the package and put the batteries in. I have very faint lines showing. Does this tool need to be returned?
- I have an older model DeWalt miter saw (DW704). Will this product work on my saw?
- I have a radial arm saw. Will this product work on my saw?
- I drilled the large hole in my door and have also drilled the small hole, but the small hole does not go all the way back to the large hole. What can I do?
- I can’t get both bubbles to line up at the same time, can you help me?
- I am crosscutting oak veneer plywood on a table saw, and the veneer is chipping on the backside. What type of blade would you recommend to cleanly cut across plywood?
Please sign in to leave a comment.